MP 44 Mixer
presents the MP 44 Mixer. Finally, a mixer that supports DJ
creativity while club sound quality and equipment remain in tact! The
MP 44s unique set of features combine with superior audio performance
to provide unparalleled value.
The MP 44 features
four Input Buses, each providing:
to the A-side, B-side or Post-Crossfader
and Line inputs
FlexFA loop assignment
full-cut Accelerated-SlopeTM Tone Controls.
Inputs are provided. Aux Input A is unbalanced, while Aux Input B is
balanced. Each Input features off to +6 dB Level controls.
Outputs are provided. Aux Output A is unbalanced. Aux Output B is
balanced. Each Output features off to -a-6 dB Level controls. Each
Output may be assigned Pre-Master Effects loop, Post-Master Effects
loop or Post Master Effects loop plus Mic. These features provide the
flexibility to use the Aux Outputs for recording or additional zones.
MCA level controls are used for House and Booth level, providing very
low travel noise and long life. A Master left/right balance control
and recessed Master Mono switch with LED indicator are provided.
Master Limiter with true RM. detectors limits both House and Booth
maximum levels. The rear panel threshold control range is ±20
dBu. Threshold indicators are provided on both the front and rear
panels.The optional Rane VR I Remote Level control may be used to
externally control the House Output. A remote DC Level Control port
allows 40 dB of Master Mix gain control. Any linear potentiometer
from I 0k to 1 00k ohms works with the internal reference. An
external ground referenced control voltage (0 to 5 VD-C) may also be
used. The gain control law is 125 mV,-dB.
Applied signal on
the Emergency Page Input automatically mutes all program material at
House and Booth Outputs. The Emergency Page level is set
independently using a recessed rear panel control.Two CD Trigger
Outputs are provided via 3.5mm (1%8") mini TRS jacks. Outputs
are normally high with 50 ms active low trigger pulses. Start is on
tip and stop is on sleeve. Ring has no connection. The CD Trigger
Enable switch is located on the front panel.